Zero

Features

This airframe was designed around the same ethos and thinking to that of its much bigger 5 inch brother, Taboo, minimalist design and simplicity.

Zero's simplicity and clean lines create a super tough and rigid structure. The use of a 1.5mm main base plate, means you have the least amount of frame flex, and also the least amount of drag over the aerodynamically optimised arms.

The protective motor brackets slot into the main frame simply and easily. These are great both for securing the motor in place but also for preventing the motor wires from getting snagged and damaged in crashes.

The fully adjustable camera gantry, allows for the camera angle to be adjusted from 0 - 90 deg. This means you can now lock in absolutely any camera angle you want. The camera gantry bolts lock this camera angle down and prevent it from moving. 

The FridayFPV Zero is capable of fitting a regular sized Rx, this means you can run any of your regular mini quad Rx's without having to go out and purchase a micro Rx. The ability to run a regular Rx, means you can now fly this frame as a proper outdoor flyer, not worrying about dropping signal if you fly more then a couple meters away from yourself.

Take your Zero outdoors and explore.

Take your Zero indoors again and race.  

Take your Zero anywhere you want to!

   FridayFPV Zero Technical Specifications

        ~ This frame is designed for 8.5mm diameter brushed motors

        ~ 96mm MTM on the diagonal

        ~ 6.5grams frame weight, including all carbon and stainless steel fasteners

        ~ 1.5mm main base plate

        ~ 0 - 90deg. fully adjustable camera angle

        ~ Protective motor brackets, stop motor wires from getting damaged.

        ~ All carbon, all stainless steel, no plastic

YouTube Build Series (Full HD)

Check out the full build series for this little monster,

https://www.youtube.com/playlist?list=PLz9PgvMeOcdIR786fzNhRc2wwdyMhZJ8H

Included

The FridayFPV Zero comes with all the necessary carbon and fasteners you need to complete this monster of a race machine. 

Also included in the kit are some really useful anti-vibration securing pads for the flight controller and camera. Zipties are included for securing the motors in place.

The use of glues (hot glue) and plastic printed parts increases overall frame weight drastically, keeping it light makes it fast!  

Carbon

1 x 1.5mm main base plate

4 x 1mm protective motor brackets

2 x 1mm camera gantry sides

2 x 1mm camera gantry tabs

1 x 1mm main camera plate

Anti-vibration adhesive pads

1 x flight control securing pad (thick)

1 x camera/vtx combo securing pad (thick) 

1 x camera/vtx combo securing pad (thin, for cameras with a plastic case)

Fasteners and Misc.

6 x 6mm M2 stainless steel button cap bolts

6 x M2 stainless steel nuts

5 x zipties (for securing motors in place)

Required

Please note, no electronics is included in this kit.

• Necessary to complete the build:
• 
  

        ~ brushed flight controller 

        ~8.5mm brushed motors (4 off)

        ~micro camera and vtx or micro camera/vtx combo

        ~ Rx, this frame is capable of fitting a regular sized Rx (removed from the case)

        ~Battery 1-2s, highest C-rating possible (150-500mAh) 

Please note the photos for this product were taken during final prototyping, finish, component flow, fastener colour and selection may change without notification.